Pipes provide fluid transport both inside buildings and outside them as well. These are installed to build piping systems for ranging purposes. Plumbing estimating services can be availed for any piping system. For optimum transportation, the pipes need to facilitate pacing inflow and outflow. But this is resisted by a number of different reasons such as blockage, damage, breakage, freezing, and others.
All of these contribute to faulty working and troubled usage. A frozen pipe is one of the major reasons.
Frozen Pipes
Both liquid and gas can freeze into solids which results in the ceasing of mobility. The liquid and gas inside the pipe are in thermal contact with it. Hence, they can freeze if the pipe’s temperature falls below the fluids’ freezing point. This condition is called frozen pipes.
In this condition, the fluid is stuck in the pipe and its mobility is completely stopped. This condition can create problems for users.
Causes of Frozen Pipes
This condition is chiefly caused by three reasons. These are:
Drop in Temperature
The most common reason all around the world is the drop in temperature. It happens in regions with very low temperatures. Overnight the temperature drop can cause the pipes to freeze and the fluid inside along with it.
Poor Insulation
While the heat loss is smooth in conductors, insulators however resist it. Therefore, insulation is installed in pipes where freezing or corrosion is feared. This insulation keeps the internal heat from escaping and keeps the environment from damage. While in the case, it is not installed, loss of heat can result in the fluid and the pipe freezing.
Too Low Set Thermostat
In advanced piping systems, the thermostat is installed. This device is meant to break the circuit just as the temperature goes out of a set range. Although safes the system, the function it is performing, and the devices connected to it. But in the case, it is set too low, the circuit does not break and the result is freezing.
Problems It Causes
Freezing pipes can be highly troublesome and require effort to put. The troubles include:
The System Ceases
As long as the fluid is frozen the piping system cannot function. The pipes become clogged. Only after the fluid is melted and boiled in its original state, the fluid can begin to remove. Until that happens, the system is of no use.
Time Wastage
Time holds a strong value in all sorts of residential, commercial, or industrial usage. Therefore, if the pipe froze and the pipes becomes clogged, time goes to waste. The concerned function has to wait and the efficiency of the piping system becomes zero.
Expenditure
The freezing leads to unnecessary expenditure. This expenditure is both in terms of the alternative means of the concerned fluid and the cost of hiring a plumber. As the fluid gets clogged, it is arranged through some alternative means. Second, some plumber is hired to get the pipes to go. This too adds up to the expenditure.
Specialized Help
Frozen pipes should be handled with care otherwise, they can damage the piping system. Any remedy can damage the pipes and different supporting materials. That is why it is best that specialized help from a plumber is hired. The plumber will carry out the needed effort to get the system going again.
Conclusion
Frozen pipes are a troublesome condition for piping systems. It is one of the conditions in which the inflow and outflow of the pipes are disturbed. The condition is about the freezing of the pipes and their constituents. This is caused by temperature drop, absence of insulation, and lowly set thermostat. The condition proves troublesome for work ceasing, time wastage, expenditure, and need for specialized help.
